Samsung Ranges Error Codes

Internal temperature of a burner rises abnormally high.

Power Off, and then Power On to the setting you want again. If the problem persists, disconnect all power to the range f...

The voltage is too high or low.

Check the power connection and make sure to turn the appliance on after regulating the voltage.

The touch-enabled IC communicates abnormally.

Restart the appliance using the POWER key. If the problem continues, disconnect power for more than 30 seconds.

Communications between main and EEP-ROM failed.

Restart the appliance using the POWER key. If the problem continues, disconnect power for more than 30 seconds.

There is a short in the control panel.

Tap Stop, and then restart the oven. If the problem persists, disconnect all power to the range for at least 30 seconds...

The door lock is misaligned.

Tap Stop, and then restart the oven. If the problem persists, disconnect all power to the range for at least 30 seconds...

Communication between the Main and Sub PBA is interrupted.

Tap Stop, and then restart the oven. If the problem persists, disconnect all power to the range for at least 30 seconds...

Communication between the Main and Touch is interrupted.

Tap Stop, and then restart the oven. If the problem persists, disconnect all power to the range for at least 30 seconds...

The oven sensor is open when the oven is operating.

Tap Stop, and then restart the oven. If the problem persists, disconnect all power to the range for at least 30 seconds...

There is a short in the Oven sensor.

Tap Stop, and then restart the oven. If the problem persists, disconnect all power to the range for at least 30 seconds...

The sub PCB sensor is open or has a short when the oven is operating.

Tap Stop, and then restart the oven. If the problem persists, disconnect all power to the range for at least 30 seconds...

The main PCB sensor is open or has a short when the oven is operating.

Tap Stop, and then restart the oven. If the problem persists, disconnect all power to the range for at least 30 seconds...

The PCB temperature rises abnormally high.

Call for service.

The power cord is installed improperly.

Reconnect the power connection properly, and the message disappears.

The sub PCB temperature rises abnormally high.

Tap Stop. Check the oven vent and cooling vent. If the vent is closed, never block the vent by anything.

Communication between the Main and Inverter PBA is interrupted.

Power Off, and then Power On to the setting you want again. If the problem persists, disconnect all power to the range f...

The top sensor is open or short when the burner is operating.

Call for service.

The IGBT sensor is open or short when the burner is operating.

Call for service.

The DC fan motor is open or locked.

Call for service.

Improper power connection

Reconnect the power connection properly.

Communication between the Main and Sub PCB is interrupted.

1. Press Stop, and the restart the oven. 2. If the problem persists, disconnect all power to the oven range for at least...

Temp probe malfunction.

Call for service.

Oven vent blocked.

1. If oven vent or cover air is blocked by aluminum foil or others, remove that and restart oven. 2.

Oven temperature did not increase normally.

1. Check if there is a proper gas supply to the oven. 2. Check if the oven liner is being used, then remove it.

Gas leakage in the gas connection section.

1. Disconnect power. Open the back cover. Check there are signs of combustion in the gas connection section. 2.