Samsung Dryers Error Codes

Operating the dryer with the door open.

Make sure the door is properly closed. Make sure laundry is not caught in the door.

Invalid power source frequency.

Try restarting the cycle. If this information code remains, contact a Samsung service center.

Electronic control problem (Invalid Communication).

Contact a Samsung service center.

High temperature heating check.

Clean the lint filter. If this information code remains, contact a Samsung service center.

The electronic control needs to be checked.

Check if power is supplied properly. If this information code remains, contact a Samsung service center.

The Thermistor1 resistance is very low or high.

Check for a clogged lint screen. Check if the vent system is restricted.

The Thermistor2 resistance is very low or high.

Check for a clogged lint screen. Check if the vent system is restricted.

Incorrect door switch.

Contact a Samsung service center.

The PBA needs to be checked.

Unplug the power plug and contact a Samsung service center.

Vent condition is good.

None needed.

The vent is clogged.

1. Clean the lint filter. 2. Check your vent condition (Refer to the 'Ducting requirements' section).

About 80% of the vent is clogged. (This may decrease the drying performance.)

1. Clean the lint filter. 2. Check your vent condition (Refer to the 'Ducting requirements' section).

Over 90 % of the vent is clogged. (This may lead to poor drying performance or cause malfunction)

1. Clean the lint filter. 2. Check your vent condition (Refer to the 'Ducting requirements' section).

The internal temperature of the dryer is too low (below 32 °F (0 °C)) or too high (over 104 °F (40 °C)) and therefore vent blockage cannot be detected.

Leave the dryer at room temperature (41~95 °F (5~35 °C)) for an hour and check again.

Unit is detecting items inside the drum or there is an error on the dry sensor.

Remove items from the drum and check again. If the problem continues, contact a service center.